Class E Power Amplifier Thesis Statements
Thesis - Campus Access Only
Master of Science (MS)
Bluetooth, class E, Class E Power Amplifier, LNA, low noise amplifier, RF Power Amplifier
This thesis researches the design of transceiver front-end RF amplifiers for Bluetooth applications in GPDK 45 nm CMOS technology. The target of the design was to minimize the transceiver's power consumption while achieving the best device operating performances. The design of a band-pass low noise amplifier (LNA) used for the receiver and the design of a power amplifier (PA) used for the transmitter were presented. Both amplifiers were designed in 45 nm CMOS technology with a DC supply voltage under 1.2 V to meet Bluetooth specifications at 2.45 GHz operating frequency. The LNA was designed to achieve a minimum small signal gain of at least 15 dB10 with a NF less than 2 dB10 and a reasonable input range for linearity at 1 mW operating power consumption. The PA was designed based on class E switching power amplifier configuration to achieve a minimum of 40% drain efficiency for 100 mW (Bluetooth Class 1) output power. Research on low power high performance Bluetooth device front-end RF amplifiers was conducted through studies of wireless communication modulation schemes, impedance matching networks, and trade-offs between performance parameters. In summation, this thesis searched for, explored, and analyzed possible methodologies that could be used to design RF CMOS amplifiers of Bluetooth applications.
Li, Ying Ying, "Design and Analysis of RF CMOS Power Amplifiers for Bluetooth Applications" (2014). Master's Theses. 4503.
Беккер кивнул. - Так, значит, вы не по поводу моей колонки. - Нет, сэр. Казалось, старик испытал сильнейшее разочарование.